WARNING! If operating the lift table improperly, a person may be seriously injured. Therefore, operate properly according to the following instruction 

1 

◇ Read & thoroughly understand the Instruction Manual completely before using. Follow all safety instructions strictly. 

◇ It is necessary to check all safety devices before operation. 

◇ Make sure that there are no obstacles in the working area. 

◇ Do not put foot or hand in scissors mechanism or through frame. 

◇ Screw the lifting eyes on the base frame before working on the lift table. 

◇ Do not overload the lift table. Load should be distributed on the table according to relevant load distribution chart. 

◇ Pay attention if local voltage and frequency is as same as the input specification of the lift table. 

◇ Use the lift table on flat and solid ground. 

2 

◇ All the electrical connection and disconnection operations must be carried out by skilled and competent personal. 

◇ While operation, it is forbidden to contact the moving parts of the lift table. 

◇ While the lift table moving, it is forbidden to adjust or to move the load. 

◇ It is forbidden to lift the load, which perhaps does harm to a person or other object. 

◇ It is forbidden to operate the lift table while a person is under the table. 

◇ Do not adjust the safety valve of hydraulic power pack. 

◇ It is forbidden to operate the lift table even if there is small structure distortion. 

◇ Do not use in an explosive or flammable place. 

Note！Maximum load refers to the load being uniformly distributed over the entire platform area. In accordance with EN1570,Safety Requirements for Lifting Tables，the basic requirements are: 

Ⅰ 100% of the rated load(maximum load) uniformly distributed over the entire platform area. 

Ⅱ or 50% of the rated load(maximum load) uniformly distributed over half the length of the platform. 

Ⅲ or 33% of the rated load(maximum load) uniformly distributed over half the width of the platform.